Sale!

Underground Cable Fault Distance Locator

6,900.00

*Free shipping
*100% Working Project
*Project Report and PPT included
*Ready to run kits

Category:

Description

The objective of this project is to determine the distance of underground cable fault from base station in kilometers. The underground cable system is a common practice followed in many urban areas.

While a fault occurs for some reason, at that time the repairing process related to that particular cable is difficult due to not knowing the exact location of the cable fault. The proposed system is to find the exact location of the fault.

The project uses the standard concept of Ohms law i.e., when a low DC voltage is applied at the feeder end through a series resistor (Cable lines), then current would vary depending upon the location of fault in the cable.

In case there is a short circuit (Line to Ground), the voltage across series resistors changes accordingly, which is then fed to an ADC to develop precise digital data which the programmed microcontroller of 8051 family would display in kilometers.

The project is assembled with a set of resistors representing cable length in KM?s and fault creation is made by a set of switches at every known KM to cross check the accuracy of the same. The fault occurring at a particular distance and the respective phase is displayed on a LCD interfaced to the microcontroller.

Further this project can be enhanced by using capacitor in an ac circuit to measure the impedance which can even locate the open circuited cable, unlike the short circuited fault only using resistors in DC circuit as followed in the above proposed project.

Hardware Requirements

  • 8051 Microcontroller
  • LCD
  • Crystal
  • ADC
  • Relays
  • Relay Driver IC
  • Transformer
  • Diodes
  • Voltage Regulator
  • Resistors
  • Capacitors
  • LEDs
  • Slide switches

Software Requirements

  • Keil Compiler
  • Language: Embedded C or Assembly.

FAQ

Q.What is the validity of the course?
Ans: It will be valid till one month from date of registration.
Q. Will the course cover hardware description?
Ans: Yes. It will cover hardware too.
Q. How many times lectures can be watched?
Ans: You can access a video lecture n no. of times during validity of your course.
Q. Will I get the certificate after completion of my course?
Ans: Yes every candidate will be awarded with certificate of training within two weeks after completion.
Q. Can I use this website in my mobile phone?
Ans: Yes but pc mode will be preferable for better understanding.
Q. Can we learn from other user registration id?
Ans: No. because we will trace the IP address of your pc, laptop, mobile if it is found unmatched with the registered id, registration will cancelled automatically and user will debarred from all services including certification.
Q: Will we get software package.
Ans: Yes u will get software package before proceeding to tutorials with how to install notes.

Block Diagram